P3855 BMW Fault Code

Description:

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to BMW PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

P3855 Code Symptoms :

The P3855 Check Engine lamp is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. P3855 diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks with your car's computers to find out exactly what's prompting the light to turn on.

Diagnosis And Repairing P3855

P3855 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

How to fix P3855 code ?

• EVAP canister or fuel tank leaks
• Faulty front heated oxygen sensor
• Faulty starter motor
• Faulty variable valve timing (VVT)

Regardless of the design though, the purpose of all clutch actuating systems is to improve the driving experience by removing the need for manual clutch operation by the driver.

Computer-controlled clutch actuating systems work particularly well in dual clutch systems where one clutch controls gear changes of even-numbered gear ratios, and a second clutch that controls gear changes of odd-numbered ratios.